2 installation – Tempest Hurricane User Manual
Page 5

Hurricane Enclosure User Manual
page 5
2 Installation
2.1 Safety and Warnings
These warnings are for your protection. Failure to comply may result in serious injury or death.
Manufacturer assumes no responsibility for damages or injury incurred by misuse or mishandling of
product.
Do not attempt to install or operate the enclosure before fully reading and understanding this
manual
This enclosure is HEAVY – do not attempt to lift with fewer than two people.
Never allow anyone who has not read this manual to open the enclosure or perform
maintenance on the luminaire within.
Never leave the enclosure unattended when open.
Even after power has been disconnected from the enclosure, the internal heater may remain
warm. Do not touch it unless you can be sure that the power has been off for at least one
hour.
Always make sure all bolts are tight and safety cables are in place after performing any form
of maintenance on the unit.
Observ
e all posted warnings in the enclosure itself.
Do not open any electrical boxes until power has been shut off to all supply lines to the
enclosure (including the one powering the projector).
Do not open the enclosure in wet weather.
Tools and Equipment
To install the enclosure, you will need the following items:
Crescent wrench
Phillips screwdriver
Proper wiring installation equipment (for line power and DMX)
Any equipment listed in the fixture manufacturer’s fixture-specific installation directions