Dataman 530 Series - Manual (Page 7)

DATAMAN 530 series AWG
User’s Guide
written materials is expressly forbidden. It is, however, allowed to pass SOFTWARE
on as the DEMO version. You may be held legally responsible for any copyright
infringement which is caused or encouraged by your failure to abide by the terms of
this License.
4. DISCLAIMER OF THE WARRANTY OF ANY KIND CONCERNING
SOFTWARE. This SOFTWARE and accompanying written materials are provided
"AS IS" without a warranty of any kind. Further, Dataman Programmers Ltd does not
warrant, guarantee or make any representations regarding the use, or the results of
use, of the SOFTWARE, device or written materials in terms of correctness, accuracy,
reliability, currentness, or otherwise. The entire risk as to the results and performance
of the software is assumed by you.
Precautions
Please observe following recommendations to avoid possible problems that might
occur while using the generator.
- read the User’s Guide
- always connect the device using a cable included in a package. If it is not possible,
always use USB 2.0 cable.
- do not connect any voltage source to the outputs.
- never connect any voltage out of -10V to +13V range to the external trigger (Si)
input (frequencies of up to 20 kHz). For frequencies higher then 20 kHz the voltage
range of –0.5 to +4V is recommended.
- never connect any voltage to the generator ground. It may result in the device, or
computer damage.
- use only the supplied wall adapter. If it is not possible, you can use any DC voltage
source in range of 10 to 18V able to supply at least 300mA. The connector’s polarity
is not important. Please be sure that no of the power supply poles are directly
connected to the ground of the device. The power supply should be fuse protected
against of overloading.
- do not open or dismantle the case, it will void any warranty. There no user
serviceable parts inside.
- 7 -