Ingenico ict220 - Manual (Page 8)

Page 7
7. An installation report will then be printed displaying the
card types that your terminal will accept.
8. Finally, the terminal will dial the Host computer to
report the successful installation.
Installation is now complete and the terminal will display
the READY prompt. Your terminal is now ready for use.
Check the date and time on your terminal. If this needs to
be corrected refer to
Section 29 of this guide for further
details.
Installing the Terminal via Ethernet (IP)
Ensure the mains supply is connected to the circular power port on the terminal’s connector box.
Ensure that the Ethernet cable is connected to the ETH port on the terminal’s connector box, and to
your router or network point.
Position the terminal in a clear area where the display can be read and the keypad and card reader
are easily accessible.
Ensure that you have your Merchant Number to hand. This can be found on your Welcome Letter.
READY
Merchant Number
12345678
READY
Merchant Number
12345678
Dual Comms Mode
You should use the keys to highlight the
required option and then press the GREEN button to select.
For installation over IP select Local Network.
1. Ensure the Ethernet cable is connected to the terminal
and press the GREEN button.
2. Key in your Merchant Number and press the GREEN
button.
The terminal will attempt to connect to the Host com-
puter and a number of communication messages will be
displayed.
The terminal may then contact any acquirers it is
configured to accept. Further communications messages
will be displayed.
3. An installation report will then be printed displaying the
card types that your terminal will accept.
Finally, the terminal contact the Host computer to report
the successful installation.
Connection Method
Telephone (PPP)
Local Network
Terminal Installation
Plug in Network
Cable
and then press ENTER
Terminal Installation
Key In Merchant No.
and then press ENTER
Terminal Installation
Connecting to
Please Wait...
READY
Merchant Number
12345678