Spectrum Controls 1769sc-HART Modules - Manual (Page 10)

Compact™ IO Isolated HART Analog Output Module
User’s Manual 0300217-03 Rev. A
1-2
Section 1.3
Hardware
Features
The module contains a removable terminal block. Each channel has a dedicated ground
which is isolated from the remaining channels by 500VDC.
Do not short the channel grounds together unless you plan to remove the
channel to channel isolation.
Module configuration is done via the controller’s programming software. In addition,
some controllers support configuration via the user program. In either case, the module
configuration is stored in the memory of the controller. Refer to your controller’s user
manual for more information. The illustration below shows the module’s hardware
features.
Figure 1-1
Item Description
1 bus lever
2a upper panel mounting tab
2b lower panel mounting tab
3 module status LED
4 module door with terminal identification label
5a movable bus connector (bus interface) with female pins
5b stationary bus connector (bus interface) with male pins
6 nameplate label
7a upper tongue-and-groove slots
7b lower tongue-and-groove slots
8a upper DIN rail latch
8b lower DIN rail latch
!
Attention
5a
9
5b
6
7a
7b
8b
7b
8a
7a
OK
HART
10a
10b
4
10
2b
3
2a 1
DANGER
Do Not Remove RTB Under
Power Unless Area is Non-
Hazardous
Ensure Adjacent Bus
Lever is Unlatched/
Latched Before/After
Removing/Inserting
Module
OK
HART