Directed Electronics SR6000 User Manual

Page 25

rreem

moottee ssttaarrtt sseeccoonnddaarryy hhaarrnneessss ((HH33)) wwiirree ccoonn--

nneeccttiioonn gguuiiddee

This wire supplies a 200mA output as soon as the module begins the remote start process. The H3/1 BLUE wire

can also be used to activate the defogger trigger (latched/pulsed) 10-seconds after the remote start engages.

(See the

Feature Descriptions section in this guide for details about programming this output.)

This wire MUST be connected to hood pinswitch. This input will disable or shut down the remote start when the hood

is opened. It will also trigger the security system if the hood is opened while the system is armed and report Zone 1.

This wire MUST be connected to the vehicle's brake light wire. This is the wire that shows (+) 12V when the brake

pedal is depressed. The remote start will be disabled or shut down any time the brake pedal is depressed. This

wire will also trigger the security system if the brake pedal is pressed while the system is armed and will report

Zone 1.

This input provides the module with information about the engine's revolutions per minute (RPMs). It can be

connected to the negative side of the coil in vehicles with conventional coils. In multi-coil and high energy igni-

tion systems locating a proper signal may be more difficult. (See

Finding the Wires You Need section of this

guide.) Once connected, you must teach the system the tach signal. (See the

Internal Programming Jumpers

section of this guide.)

3//4

4 V

VIIO

OLLEETT//W

HIITTEE ttaacch

meetteerr iin

utt

3//3

3 B

N ((+

+)) b

brraakkee ssw

wiittcch

h iin

utt,, zzo

nee 1

3//2

2 G

Y ((--)) h

d p

piin

nssw

wiittcch

h iin

utt,, zzo

nee 1

3//1

1 B

BLLU

UEE//W

HIITTEE ((--)) ssttaattu

uss o

uttp

utt