Directed Electronics SR6000 - Manual (Page 17)

1 17 7
pprriim maarryy hhaarrnneessss ((HH11)) wwiirree ccoonnnneeccttiioonn gguuiiddee
This wire supplies a (-)500 mA ground as long as the system is armed. This output ceases as soon as the system
is disarmed. The orange wire may be wired to an optional starter kill relay.
As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under
the sliding door is moved to the opposite position (see Internal Programming Jumper section of this guide), this
wire supplies a (-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some
Mitsubishi, some Mazda, and other model cars.
((+ +)) P Po ossiittiivvee LLiig gh htt FFllaassh h O Ou uttp pu utt
((--)) LLiig gh htt FFllaassh h O Ou uttp pu utt
N NO OTTEE:: For parking light circuits that draw 10 amps or more, the internal jumper must be switched
to a (-) light flash output. (See the Internal Programming Jumper section of this guide.) P P//N N
8 86 61 17 7 or a standard automotive SPDT relay must be used on the H1/2 light flash output harness
wire.
H H1 1//2 2 W WH HIITTEE ((+ +//--)) sseelleeccttaab bllee lliig gh htt ffllaassh h o ou uttp pu utt
H H1 1//1 1 O OR RA AN NG GEE ((--)) g grro ou un nd d--w wh heen n--aarrm meed d o ou uttp pu utt