Brother FAX-195 User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

IMPORTANT NOTE: If there are no messages on your TAD, you will hear a series of short
beeps.

Now, you are ready to request the FAX-195's TAD to perform some functions. These functions
and the remote commands needed to activate them are shown in the table below.

FUNCTION

COMMAND

DESCRIPTION

Play back message/memo # 1 0

# 1 3

• Pressing * while message/memo is playing will bring you forward to the following

message/memo.

Erase message/memo

#20

# 2

# 2 2
#2 3

• You may continue this until #28 if

messages.

Record message/memo

#30

Record/Change OGM

#40

Playback OGM

#41

FAX message count

#50

All messages

First message

Second message
Third message

the Number of ICM is set at eight (8) 14-second

Record new message at once

Maximum of 255 messages are counted.

The counter is cleared each time the unit

is set to TAD.

VOICE message count

#60

TAD OFF

#70

TAD ON

#71

Counts the number of ICM in TAD.

Turns the TAD off.
Turns TAD on.

AUTO PAGE OFF
AUTO PAGE ON

#80

Turns off the AUTO PAGE function.
Turns ON the AUTO PAGE function.

Terminate Remote Control #90

Terminates the operation. If you do not
order this termination, the unit will cut
the connection automatically in 30
seconds unless you issue another
command.

NOTE: A short beep is heard repeatedly for 30 seconds when each function has been

completed. To continue with another function, press # within 30 seconds after a 1 sec. beep.

The FAX MESSAGE COUNT is a feature unique to Brother. Its main purpose is to save you a
trip to check on the arrival of that important fax message you've been waiting for. If the count

is zero, there is no need to rush back.