Zp^ fax "100 – Brother FAX-195 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
18
2
.
3.
To set a user-selectable function:
1. Turn the power OFF.
"CAUTION: BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE EVENT
OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNIT'S MAIN POWER SWITCH."
Turn the power ON again while depressing the FINE/PHOTO button.
The unit will automatically print out:
**** ***********CURRENT USER SWITCH SETTING***“************
*
*
*
USER SWITCHES: 0000000
*
*
************************** gpQ-|-|_l^p FAX“1 Q5**************************
The FINE lamp will blink.
Select the digit you wish to change and press the FINE/PHOTO button the appropriate
number of times. For example, to select digit 2, press FINE/PHOTO button twice.
Press START/COPY button to enter the selection.
Now, you can change the factory setting of "0" to the optional setting of "1". To enter
"1", press FINE button once. Press START/COPY button to register this choice.
(Note that pressing theSTART/STOP button without pressing FINE/PHOTO button
beforehand, selects and registers a "0"). The unit will automatically print out:
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE? *******
*
*
*
NEW USER SWITCHES: 0100000
*
*
|[zp^ FAX "100***********************************
4.
5.
6
.
********************r
The START/COPY lamp will start to blink.
7.
If your entries are incorrect, press the STOP button and then the START/COPY
button. The FINE lamp will start to blink. This will bring you back to step 4 where you
can select this procedure all over by pressing the FINE/PHOTO button five (5) times
and then going throrough the rest of the procedure.
If your entries are correct, press the START/COPY button to complete the selection
of numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other switches. To do so, you press START/COPY button again which
will bring you back to step 4 above and where you can use the FINE/PHOTO button to
select the desired switch. Choice (2) is to terminate the registration process by
pressing the STOP button.
NOTE: Your entries, e.g., the RTI/TTI and user switch, etc. can be verified by printing out the
SYSTEM CONFIGURATION LIST. We will explain how to do this in a later section.