Brother FAX-195 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The factory setting for this FOUR-DIGIT CODE is 0000. Here is an example of how you can
change this setting to 1204.

As shown on page 12, the process of registering theFAX PASSWORD starts by pressing the

FINE/PHOTO button once in step 3. The following steps are:

Press the START/COPY button to print out the password that is currently registered
in the unit. The foilowing will be printed out:

I. SETTING THE FAX PASSWORD

***************

CURRENT FAX PASSWORD

FAX PASSWORD: 0000

*********************

**************************

BROTHER FAX-195

**************************

To register the new password press FINE/PHOTO button once to seiect the first digit

II -j II

Press START/COPY button to register this digit.

Press FINE/PHOTO button twice to select "2".

Press START/STOP button to register the "2".

To register the third digit - "0" - press START/COPY button. This both selects and

registers a "0".

10. Press FINE/PHOTO button four times to select the final digit "4".

11. Press START/COPY button to register this final digit and the FAX-195 will

automatically print out:

**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE? *******

★

NEW FAX PASSWORD: 1204

‘BROTHER FAX-195*

********************r

-***********************************

The START/COPY lamp starts to blink when the printout is completed.

12. If your entries are incorrect, press the STOP button and then the START/COPY

button. The FINE lamp starts to blink. This will bring you back to step 3 where you can
select this procedure all over again by pressing the FINE/PHOTO button once and
going through the subsequent steps.

If your entries are correct, press the START/COPY button to complete the selection

of numbers. Now you have two choices. Choice (1) allows you to continue with

registration of other parameters. To do so, you press START/COPY button again

which will bring you back to step 3 above and where you can use the FINE/PHOTO

button to select the desired parameter. Choice (2) is to terminate the registration
process by pressing the STOP button.