Attribute ids supported by the instance service – KEYENCE DL-EP1 User Manual
Page 78
- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (GT2) -
3-4 Message Communication
3-48
3
C
om
m
uni
ca
tin
g
w
ith
the
G
T2
S
er
ies
• Responses (when unsuccessful)
For details on the attribute ID, settings, general status, and additional status of each
parameter, refer to
"DL Object (Class ID:67H)" (Page 3-31) and
(3) Issuing operation commands to a sensor amplifier
Message communication issues operation commands such as error clear to the
sensor amplifier connected to the DL-EP1.
Service code 4BH is used.
The following settings are required to use this object.
• Service Code
• Class ID
• Instance ID
• Attribute ID
• Attribute IDs supported by the instance service 4BH (operation command)
The contents of processing performed by the instance service 4BH (operation
command) depend on the attribute ID to be selected.
The table below details the attribute IDs that can be selected.
• Commands
Item
Description
Data Example
General status
A general status for the service is returned
0EH
Additional status
An additional status is returned.
-
Service response data
There is no service response data.
-
Name
Description
Attribute ID
Perform preset request
Executes preset.
0301H(769)
Perform preset reset request
Executes preset reset.
0302H(770)
Reset request
Executes reset.
0303H(771)
Error clear request
Executes error clear.
0304H(772)
Initial reset request
Resets the value to the initial value.
0305H(773)
Item
Description
Data Example
Service Code
Designates the "operation command (4BH)" (fixed
value).
4BH
Class ID
Designates DL Object (67H)(fixed value).
67H
Instance ID
Designates the ID number. The ID number (00H) of the
DL-EP1 cannot be designated.
08H