Inovonics FA104 - Manual (Page 13)

© 1994 INOVONICS Corporation
9
LIT-FA104-USER 14-Nov-95
Programming C404 Slave Receivers
Press
ENTER to program or modify transmitter settings.
Press
!
to go to DELETE POINTS menu option or
"
for RECEIVER SETUP.
Enter point number from keypad. Press ENTER.
Is the transmitter a C100 Commander?
Arrow keys toggle between YES and NO.
Is the external switch loop normally open or closed?
Arrow keys toggle between NORM/OPEN and NORM/CLOSED.
Is a 2.2K end of line resistor being used to monitor the switch loop?
Arrow keys toggle between NO and YES.
Is C200W widegap magnet contact being used? Arrow keys toggle
between NO and YES.
How often should supervisory data be transmitted?
Arrow keys toggle between UNSUPERVISED and
10, 30, or 60 SECONDS.
Press
ENTER to proceed with transmitter programming,
or press A to go through transmitter options again.
Connect transmitter and press transmitter reset to program device, or press A
to save point program and select a new point number.
Indicates successful transmitter programming sequence. Display remains for
about 3 seconds, then returns to the point number selection screen.
POINT NUMBER:
ENTER #(1 to 4)
4-BUTTON TX:
! YES "
ENTER TO PROGRAM
"A" to REVIEW
RESET TX +CONNECT
OR PRESS "A"
POINT NUMBER nn
Tx PROGRAMMED
CHECK-IN TIME
!
60 SECONDS
"
USE INTERNAL
CONTACT: ! NO "
END OF LINE
RESISTOR: ! NO "
EXT SWITCH TYPE
! NORM/OPEN "
Program
Points
Press ENTER to
! PROGRAM POINT "
THESE OPTIONS
ARE SKIPPED IF
4-BUTTON TX
= "YES"