Ih-vcrplus+jpro, Easy taping, Before you begin, make sure – Panasonic PV-M2037 User Manual
Page 24: Use normal timer recording steps if, To make corrections, To change the recording speed, To cancel program contents, Push prog to display the “set program” screen, See page 19 to, Push prog to lock in your program
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^^^|iH-VCRPlus+JPro
Easy Taping
Before you begin, make sure...
□ The clock is set.
□ VCR Pius+ Set Up is complete (See pages 22, 23).
Push PROG to
display the “SET
PROGRAM” screen.
............SET PROGRAM.....................
VCR Plust PROGRAM
TIMER PROGRAM
SEI.ECT : A ▼ KEY
SET :► KEY
END :PHOG KEY
PROGRAM TIMER Indicator
Use normal Timer Recording steps if:
• the PlusCode for a program is not listed.
• you anticipate the program, such as a
sporting event, to run over the scheduled
stop time.
See page 19 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
Pushm Vto select
“VCR Plus+
PROGRAM,” and
then push to
display the Plus
Code screen.
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
:PROG KEY
Push NUMBERED keys to
enter the PlusCode number
from your local TV listings.
To Make Corrections
PushO repeatedly to delete the PlusCode number.
Then, enter the correct number.
Push PROG to lock
in your program.
ENTER PLUSCODE NUMBER
123456
USING 0-9 KEYS
BACKSPACE:4
KEY
ENTER :PROG KEY
d)
Push the 1,2, or 3 key to
select the program type.
1 ONCE
2 DA ILY(MON-FRI)
3 WEEKLY
TO SELECT PUSH 1, 2 OR 3
END : PROG KEY
To Change the Recording Speed
Push SPEED for SP, LP, or SLR
To Cancel Program Contents
Push ADD/DLT.
• If you use connection type "A” on page 22,
the channel shown in this on-screen display
will always be the cable box output channel number.
DATE START STOP CH
8 SAT 10:OOP12:OOP125
SLP
TO CHANGE RECORD SPEED
PUSH SPEED KEY
CANCEL;ADO/DLT KEY
ACCEPT:PROG KEY
Push PROG three
times to complete
the program.
The PROGRAM TIMER indicator
lights on the front panel.
If you’re using a cable box, make
sure that it is tuned to the desired
channel and the power is left on for
timer recording.
LEAVE CABLE BOX POWER ON
FOR TIMER RECORDING
This display
appears if you use
a cable box.
24
For a list of publications that carry the PlusCode numbers in your area, call 1-800-258-4827.
You can obtain unlisted PlusCode numbers by calling 1-900-454-7587. Call costs approximately $.95 per minute.
Avoid overlapping program times.
An on-screen display will indicate if an invalid PlusCode number has been entered.
An on-screen display will indicate when all timer programs are full.