Panasonic NV-SD250 - Manual (Page 16)

Manual Tuning Procedure
1 Press MENU.
2 Select TUNER PRESET by pressing A or T and
ENTER.
3 Select CH by pressing A or ▼ and then select the
programme position by pressing ◄ or ►.
4 Confirm that CLEAR is set to OFF,
5 Select SEARCH by pressing A or ▼ and then press ►.
CH2 SEARCH
J
• If the desired TV station is not be tuned, press ► again.
• Press MENU and repeat steps 3-5 for each
programme position you want to tune to a station.
6 Press MENU three times.
Channel Plan
VHF
UHF
VL VH
NV-SD250A 0-5 5A-12 21-69
NV-SD250EA 1-3 4-1 1 21-69
NV-SD250A:
Broadcast TV Channel Position tuned on VTR
2 ABC 2
7ATN 7
9TCN 9
10TEN 10
28 SBS 28
Fine Tuning Procedure
1 Press MENU.
2 Select TUNER PRESET by pressing A or ▼ and
ENTER
3 Select CH by pressing A or T and then select the
programme position by pressing ◄ or ►.
4 Select FINE by pressing A or T .
5 Press ◄ or ► to obtain the best tuning condition.
•To return the tuning to its former state, press ENTER.
6 Press MENU.
Blanking of Unoccupied Programme
positions
1 Press MENU.
2 Select TUNER PRESET by pressing A or ▼ and
ENTER.
3 Select CH by pressing A or ▼ and then select the
programme position by pressing ◄ or ►.
4 Select CLEAR by pressing A or ▼,
5 Select ON by pressing ◄ or ►.
• Repeat steps 3-5 tor another unoccupied programme
positions to skip during the selection of the programme
positions.
•To cancel the blanking of a programme position, select
that programme position and then select CLEAR OFF.
6 Press MENU twice.
This table will be required when programming the G-Code,
16