Tuning the tv to your vtr, Nv-sd250a, Operations – Panasonic NV-SD250 User Manual
Page 10: Note, Tuning the tv to your vtr: nv-sd250a, Nv-sd250ea
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning the TV to your VTR
: NV-SD250A
The VTR supplies a signal to the TV set via the RF coaxial
cable on channel 37.
It is possible to view the video picture on your TV in the
same way that you watch TV broadcasts.
If you have connected the VTR to the TV through the video
and audio input sockets then you do not need to follow the
procedure mentioned below.
Operations
1
POWER C!)/I
o
Turn on the TV and VTR.
2
TEST
signal
OFF ON
Ml
To generate a test pattern, set
TEST
SIGNAL
to ON.
Set the TV to an unused position which you
wish to use for your video playback.
3
|i
b';
m
li
■!
4
TEST SIGNAL
OFF ON
LU
Set
TEST SIGNAL
to OFF.
10
Note:
The test signal is transmitted on video channel 37.
If you are encountering interference from a TV broadcast
on this video channel, you may readjust to another free
channel (31 -43) by using the CH ADJ. screw which is
located on the rear of the VTR.
Please note that if the CH ADJ. screw is used then you will
have to retune your TV to the test signal as in item 2 to 4
above.