Tape-to-tape recording, Press [rev mode] to select the reverse mode, Press [tape edit – Panasonic SC-DV100 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tape-to-tape recording
Preparations:
® Press Standby/on switch to turn the unit on.
(D The leader tape must be wound on beforehand. page 39)
@ Insert a tape into each deck.
DECK 1: For playback
DECK 2: For recording
Press [REV MODE] to select the reverse mode.
One side will record, then recording will stop auto
matically.
czlb: Both sides will record (forward side-»reverse side),
then recording will stop automatically.
Set the tape direction “t>” of deck 1 and 2.
Press [DECK 1/2] and confirm both deck’s tape directions are
To change the tape direction, first press [>], and then [■].
To record on the reverse side, set deck 2 to
Press [TAPE EDIT].
Recording will begin.
If you select “c^D” in step Q, when you press [TAPE EDIT],
automatically switches over to
The tape direction indicator (“<3’’ or “O”) shows deck 2 direction.
If either deck 1 or deck 2 stops, the other deck also stops.
To stop recording
Press [■].
Both decks will stop.
To display the tape counter while recording
Press [COUNTER DISPLAY).
The tape counter will be displayed for approximately 5 seconds.
To enjoy another source while recording
Start playing the other sound source.
You can change the volume, sound quality and surround effect with
out affecting the recording.
The recording level and the noise reduction effect of the original
(playback) tape will be recorded on the new tape.
I
s
o
&
0
>
c
o
u
o
Q£
RQT5056