Panasonic PV-4664 - Manual (Page 27)

Connections you’ll need to make. (Choose front or rear connection.)
Playing (Source) VCR Recording (Editing) VCR TV for Monitoring
Insert a pre-recorded
tape into the Playing
(Source) VCR.
^r~
Insert a blank tape
with record tab into the
Recording (Editing) VCR.
Select Input “LINE” on the
Recording (Editing) VCR.
(See “Selecting the
Input Mode” at right.)
Push PLAY on Playing VCR.
Push PAUSE at the point you
want to start copying.
Push REC and PLAY at the
same time on Recording VCR.
Push PAUSE immediately.
Push PAUSE on both
VCRs (at the same time),
to_begin copying.
Edit Out Unwanted Parts
of the original recording by using the PAUSE button
(on the Recording unit) while copying is in progress.
Push STOP on both
VCRs to stop copying.
To Monitor the Re-Recording
1
Turn the TV on and select its VCR channel
(CH3 or CH4) on the Recording VCR.
2
Set the VCR/TV selector on the Recording
VCR to the “VCR” position.
Selecting the Input Mode
1
Push MENU to display the
menu.
2
Rotate and push the Wheel
to select SET UP VCR.
.................. MENU ...................
ÎET Cu
SET UP CHANNEL
IDIОМА/LANGUE: ENGL ISH
SELECT
SET
END ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
-- SET UP VCR
ON
ON
LINEI
Rotate the Wheel to select
“INPUT SELECT”, and then
push to choose TUNER or
LINE (LINE1 or LINE2).
• LINE1; For rear audio/video
connection.
LINE2: For front audio/video
connection.
• You can also select “LINE1" or “LINE2” using the
VCR CH
A/'T
buttons.
The numbers will change in the order shown.
REPEAT PLAY
BEEPER
SET AUDIO MODE
SET UP COMMERCIAL ADV.
SELECT : ROTATE WHEEL
SET
; PUSH WHEEL
END ; PUSH MENU KEY
When LINE is selected, “L1” or L2” is displayed in
the Multi Function Display for about 4 seconds.
Caution:
Unauthorized exchanging and/or copying of copyrighted
recordings may be copyright infringement.
27