Panasonic PV-4664 - Manual (Page 16)

П Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the Channel
number will appear for a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.)
the VCR mode will be
displayed.
08
.................. MENU ...................
SET UP VCR
ID10MA/ LAMGUE: ENGLISH
Menu Screen
1 Push MENU to display
the menu.
2 Rotate and push the wheel
to make your selection
(see page 12).
To get the most from each feature, it is
recommended that you read the Operation
Manual before attempting any operation.
SELECT
SET
END : ROTATE WHEEL
: PUSH WHEEL
: PUSH MENU KEY
Warning and Instruction Displays
These displays will alert you to a missed operation or
provide further instructions.
WNET
If no active channels are
found for CHANNEL
MEMORY...
>
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
^
^
If you attempt to set or
review a Timer Recording
and the Clock is not set...
PLEASE SET CLOCK
BEFORE PROGRAMMING
If a Timer Program was not
completed before exiting
the Program mode...
PROGRAM IS INCOMPLETE
VCR Status & Clock Display
Push DISPLAY to display and remove the
overlay shown below.
After a Timer Program
has been set...
TURN VCR OFF
FOR TIMER RECORDING
Function Status Time
RecTime -
Remaining
(OTR mode only
see page 18.)
REC 12:00AM СНОВ
0 : 25 0:00:00
STEREO <- ! SUP
SAP
MONO
\
Receivable
Broadcast Types
(See page 28.)
Counter
Channel &
Call Letter
Tape Speed
If you push REC on the
remote control or REC
and PLAY on the VCR,
and a cassette is inserted
with no record tab...
If you push PLAY, FF, REW,
or REC on the remote control
or if you push REC and
PLAY, PLAY, FF, REW, or
REC on the VCR without a
cassette inserted...
CHECK CASSETTE
RECORD TAB
;
NO CASSETTE
PLEASE INSERT A CASSETTE
Blank Tape and will be Blue Screen
If a blank section of tape is encountered in the Play
mode or the channel you select has no broadcast,
the TV screen will change to a solid blue field.
The screen will remain blue until a recorded signal
is again detected or an active channel is selected.
If you push POWER or
STOP during a Timer
Recording...
(visible in VCR mode only)
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
16