Yamaha disklavier Mark II XG Series - Manual (Page 2)

FCC INFORMATION (U.S.A.)
IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modil'ications not expressly
approved by Yamaha may void your authority, granted by the FCC, to use the product.
IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to
use this product in the USA.
NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital
devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environ­
ment will not result in harmful interferenee with other electronic devices. This equipment generates/uses radio frequencies and, if not in­
stalled and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic
devices. Compliance with FCC regulations does not guarantee that interference will not occur in ail installations. If this product is found to
be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using
one of the following measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filtci7s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to
co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product.
If you can not locate the appropriate retailer, please contact Yamaha Corporation oi’America, Electronic Service Division,
6600 Orangethorpe Avc, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
IMPORTANT NOTICE FOR THE UNITED KINGDOM
Apply for Upright Models
Connecting the Plug and Cord
IMPORTANT: The wires in mains lead are coloured in accordance with
the following code:
BLUE
BROWN NEUTRAL
LIVE
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE mu.st be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN mu.st be connected to the terminal
which is marked with the letter L or coloured RED.
Making sure that neither core is connected to the earth termiiiiil of the three
pin plug.
CANADA
This Class B digital apparatus meets all requirements of the
Canadian interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les
exigences du Règlement sur le matériel brouilleur du Canada.
Apply for Upright Models
Uniquement pour les pianos droits
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE
OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION; POUR EVITER LES CHOCS ELECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA
BORNE CORRESPONDANTE DE LA PRISE ET POUSSER
JUSQUAU FOND.
IMPORTANT NOTICE FOR THE UNITED KINGDOM
Apply for Grand Models
Connecting the Plug and Cord
IMPORTANT: The wires in mains lead arc coloured in accordance with
the following code:
GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured GREEN and YELLOW must lie connected to
the terminal in the plug which is marked by the letter E or by the .safety
earth symbol or coloured GREEN and YELLOW.
The wire which is coloured BLUE mu.st be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal
which is marked with the letter L or coloured RED.
Alleen voor klanten in Nederland
Bij dit Produkt zijn
batterijen geleverd.
Wanneer deze leeg
zijn, moet u ze niet
weggooien maar
inleveren als KCA.
IMPORTANT SAFETY INSTRUCTIONS
INFORMATION RELATING TO PERSONAL INJURY, ELECTRICAL SHOCK,
AND FIRE HAZARD POSSIBILITIES HAS BEEN INCLUDED IN THIS LIST.
WARNING — When using any electrical or electronic prod­
uct, basic precautions should always be followed. These pre­
cautions include, but are not limited to, the following:
\ _ Read all Safety Instructions, Installation Instructions,
Special Message Section items, and any Assembly
Instructions found in this manual BEFORE making any con­
nections, including connection to the main supply.
2^ Main Power Supply Verification: Yamaha products are
manufactured specifically for the supply voltage in the
area where they tu'e to be sold. If you should move, or if any
doubt exists about the supply voltage in your area, please
contact your dealer for supply voltage verification and (if
applicable) instructions. The required supply voltage is printed
on the name plate. For name plate location, please refer to the
graphic found in the Special Message Section of this manual.
3 This product may be equipped with a polarized plug (one
blade wider than the other). If you are unable to insert the
plug into the outlet, turn the plug over and try again. If the
problem persists, contact an electrician to have the obsolete
outlet replaced. DO NOT defeat the safety puipo.se of the plug.
4. DANGER — Grounding Instructions: Disklavier Grand
must be grounded and therefore has been equipped with
a three pin attachment plug. If this product should malfunction,
the ground pin provides a path of low resistance for electrical
current, reducing the risk of electrical shock. If your wall socket
will not accommodate this type plug, contact an electrician to
have the outlet replaced in accordance with local electrical
codes. Do NOT modify the plug or change the plug to a
different type!
5, WARNING: Do not place this product or any other
objects on the power cord or place it in a position where
anyone could walk on, trip over, or roll anything over power or
connecting cords of any kind. The use of an extension cord is
not recommended! If you must use an extension cord, the
minimum wire size for a 25’ cord (or less) is 18 AWG. NOTE:
The smaller the AWG number, the larger the current handling
capacity. For longer extension cords, consult a local electrician.
^ Ventilation: Electronic products, unless specifically de­
signed for enclosed installations, should be placed in
locations that do not inteifere with proper ventilation. If
instructions for enclosed installations are not provided, it must
be assumed that unobstructed ventilation is required.
7^ Temperature considerations: Electronic products should
be installed in locations that do not significantly contrib­
ute to their operating temperature. Placement of this product
close to heat sources such as; radiators, heat registers and other
devices that produce heat should be avoided.
This product was NOT designed for use in wet/damp
locations and should not be used near water or exposed to
rain. Examples of wet/damp locations are; near a swimming
pool, spa, tub, sink, or wet basement.
9. This product should be used only with the components
supplied or; a cart, rack, or stand that is recommended by
the manufacturer. If a cart, rack, or stand is used, please observe
all safety mtu'kings and instructions that accompany the acces-
S017 product.
10. The power supply cord (plug) should be disconnected
from the outlet when electronic products are to be left
unused for extended periods of time. Cords should also be
disconnected when there is a high probability of lightning
and/or electrical storm activity.
I \ ^ Care should taken that objects do not fall and liquids tu'e
not spilled into the enclosure through any openings that
may exist.
12. Electrical/electronic products should be .serviced by a
qualified service person when:
a. The power supply cord has been damaged; or
b. Objects have fallen, been inserted, or liquids have
been spilled into the enclosure through openings; or
c. The product has been exposed to rain; or
d. The product does not operate, exhibits a marked
change in performance; or
e. The product has been dropped, or the enclosure of
the product has been damaged.
13 . Do not attempt to service this product beyond that
de.scribed in the user-maintainance instructions. All other
servicing should be referred to qualified .service personnel.
14 . This product, either alone or in combination with an
amplifier and headphones or speaker/s, may be capable of
producing sound levels that could cause permanent hearing
loss. DO NOT operate for a long period of time at a high
volume level or at a level that is uncomfortable. If you
experience any hetu'ing loss or ringing in the ears, you should
consult an audiologist. IMPORTANT: The louder the sound,
the shorter the time period before damage occurs.
15 . Some Yamaha products may have benches and/or acces-
soiy mounting fixtures that are either supplied as a part or
the product or as optional accessories. Some of the.se items are
designed to be dealer assembled or installed. Please make sure
that benches are stable and any optional fixtures (where
applicable) are well secured BEFORE using. Benches supplied
by Yamaha are designed for seating only. No other uses are
recommended.
92-469-DK
(D PLEASE KEEP THIS MANUAL