Yamaha disklavier Mark II XG Series - Manual (Page 12)

(D
TO CONTROL CABLE FOR PIANO
The control cable from the piano is connected
here.
® MIDI IN
This connector provides access to the
Disklavier and internal XG tone generator. You
can connect a MIDI keyboai'd, synthesizer, or
MIDI sequencer to control the Disklavier,
internal XG tone generator, or both.
C5) MIDI OUT
This connector is used to output MIDI data
from the Control Unit. It allows output to
MIDI-compatible tone generators,
synthesizers, samplers, etc.
® OUTPUT R, L/MONO
These connectors are used to output audio
signal from the internal XG tone generator.
For Ensemble song playback, powered
speakers should be connected to these
terminals.
If your system is mono, use only the L/MONO
connector.
Mains Switch & Foot Controller
Foot Controller connector Mains switch
® MAINS (ON/OFF) switch
This switch is used to switch the Disklavier on
and off. See pages 13 and 14 for information
on power ON and OFF procedures.
Note: The MAINS switch only needs to
be switched off when you are not
going to
Li.se
the Disklavier for a
long period of time. For daily use,
only the [STANDBY - ON] button
on the Control Unit needs to be
switched on and off.
@ FOOT CNTRL connector
An optional Yamaha FC-4 or FC-5 foot switch
can be connected here for starting and pausing
playback, and recording.
The optional Yamaha FC-7 foot controller pro­
vides control over playback tempo, as well as
the above functions.
10
Chapter 2 : Names of Parts and Their Functions
Remote Control
©-
PART SELECT
L )) |( R
SEARCH
REV*FWD VOLUME
SONG SELECT
PAUSE STOP
®
YAMAHA
REMOTE CONTROL TRANSMITTER PPR-100
® [RECORD] button
Press to engage the Record Standby mode
before recording stalls.
@ Number keypad*
Used for direct song selection and to enter a
start time for song playback.
@ [REPEAT] button*
Used to select one of the Repeat functions:
ALL, RPT, or RND.
® [A-B] button*
Used to enter A and B points for Segments
A ~ B and A ~ Repeat modes.
® [REV FWD] buttons
In Play mode, these buttons work as fast
preview and review.
In Pause mode, they work as fast forwm-d and
reverse.
® [SONG SELECT] buttons
U.sed to select songs.
® [PLAY] button
U.sed to start playback.
® [PAUSE] button
U.sed to pau.se playback and recording.
® [STOP] button
U.sed to stop playback and recording.
® [PART SELECT] buttons
For L/R and Ensemble songs, these buttons
ai*e used to choose which part will play; left-
hand pail, right-hand pai1, or both parts. They
are also u.sed to .select a part for recording.
® [SEARCH] button*
Used to stai't playback from a specific time in
a song. Press this button, enter the stmt time
using the Number keypad, then press this
button again.
® [TRANSPOSE] buttons
Used to transpose song playback.
Press the [-] button to transpo.se down, the [+]
button to transpo.se up.
The [0] button is used to re.set the transposition
value to 00.
® [TEMPO] buttons
U.sed to change the playback tempo.
Press the [-] button to decrease the tempo, the
[+] button to increase the tempo.
The [0] button is u.sed to reset the tempo to 00.
® [VOLUME] buttons
Used to adjust the volume.
Press [-] button to decrease the volume, and the
[+] button to increa.se the volume.
* These buttons are available only on the remote
control.
Remote Control 11