Output specifications, Dimensions, Output specifications dimensions – Yamaha RM800 User Manual
Page 39: Specifications
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
36
Specifications ,
Output Specifications
Output Connection
Actual Source
For Use with
Output Level
*
Mixer Connector
Impedance
Nominal
Nominal
Max. Before Clip
STEREO OUT L/R (+4)
150 a
600 O lines
+4 dB (1.23V)
+24 dB (12.3V)
Phone jack (TRS) *1
STEREO OUT L/R (-10)
600 0
10k O lines
-10dBV(316mV)
+10 dBV (3.16V)
Phone jack *3
CONTROL ROOM OUT
75 O
600 O lines
+4 dB (1.23V)
+20 dB (7.75V)
Phone jack *3
CROUP OUT (+4)
75 0
600 O lines
+4 dB (1.23V)
+20 dB (7.75V)
Phone jack *3
CROUP OUT (-10)
600 0
10k O lines
-10dBV(316mV)
+6 dBV (2.00V)
Phone jack *3
AUX, MONI/AUX SEND
75 0
600 O lines
+4 dB (1.23V)
+20 dB (7.75V)
Phone jack *3
INSERT OUT
(CH, ST, GROUP 7/8)
600 0
10k O lines
0 dB (775mV)
+20 dB (7.75V)
Phone jack (TRS) *2
TAPE SEND
(CH9-16/17-24)
600 0
10k O lines
-10dBV(316mV)
+6 dBV (2.00V)
Phone jack *3
PHONES OUT
100 0
40 O phones
3mW
lOOmW
Stereo phone jack
*1. Phone jacks are balanced (Tip=HOT, Ring=COLD, Sleeve=CND).
*2. Insert phone jacks (TRS) are unbalanced (Tip=out, Ring=in, Sleeve=
*3. Phone jacks are unbalanced.
•
In these specifications, when dB represents a specific voltage, OdB
specific voltage, OdBV is referenced to 1 volt RMS.
•
All specifications subject to change without notice
=GND).
is referenced to 0.775 volts RMS, for TAPE SEND dBV represents a
Dimensions
16CH=668. 24CH=908
CH
16
24
W2
668
008
W1
767
1007
W
807
1047
RM800 User's Cuide