Tag operations, Workflows – ThingMagic Universal Reader Assistant 2.6 User Manual
Page 24
Tag Operations
Universal Reader Assistant v2.6 User Guide
24
Tag Operations
Universal Reader Assistant 2 currently supports the following individual Tag Operations:
All Tag Operations Tabs support two main workflows which define what tag will be
operated on.
Workflows
1.
User Clicks on one of the tag operation tabs. This causes the following behavior:
First tag to respond is selected. This means when an operation is performed
it will be performed on the first tag to respond. If more than one tag is in the
field the tag to be operated on is non-deterministic. Clicking Read/Refresh
buttons will often provide a warning indicating that more than one tag was
found.
The first detected/selected antenna will be used for the operation.
2.
User right-clicks on EPC ID or Data (from enabling an Embedded ReadData)
cell in the
and selects a tag operation. This causes the
following behavior:
A Select filter will be applied when the selected tag operation is invoked. The
select filter to be applied will be shown in the top section of the operation tab.
The antenna the tag was read on (add the Antenna column in
to the
to see which) will be used for the tag
operation.
Note
Following workflow #2 does not guarantee the operation will be isolated to a
specific tag. If you are not certain if the select critieria only applies to a single tag
the Read/Refresh button can be used to check. Clicking it a few times should
always show the same data and should not result in any warnings.