Hollywood Racks HR1000R SportRider 2 Recumbent - Manual (Page 8)

Double check before driving off :
- Knobs are tight on all four wheel trays and
- Frame hooks are pushed all the way down
- All three retaining pins are properly inserted and secure
- Wheel straps are fastened
- Hitch pin is secure and hitch pin clip is installed
- Drive slowly on bumpy or dirt roads
Optional accessories for your Sport Rider
Locking threaded
hitch pin
part no. LHPT
Trike
Adapter
Part No.
TRK-ADP
Locking Threaded
hitch pin with
security cable
part no. LHPTC
Limited Lifetime Warranty (effective January 1, 2008):
Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser owns the product subject
to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in materials and workmanship by repairing or
replacing (at its option) a defective part or the complete rack without charge for labor or parts. Hollywood Racks may elect (at its option)
to issue a refund equal to the purchase price paid for the product.
This warranty does not cover problems caused by normal wear and tear including (but not limited to) weather, scratches, dents, rust,
accidents, unlawful vehicle operation, misuse, abuse, neglect, theft, unauthorized modifications, or unauthorized repair. No warranty is
given for defects resulting in incorrect assembly, incorrect installation onto the vehi
cle, installation on a “no fit” vehicle, incorrect
attachment of bicycles onto the rack, or overloading of the rack’s weight restrictions. This warranty terminates if the original retail
purchaser transfers the product to any other person. If a product is believed to be defective, the original retail purchaser should contact
either the original retailer or Hollywood Racks directly at 800-747-4085 or at [email protected]
Disclaimer of Liability: Repair or replacement of a defective product or the issuance of a refund or credit (as determined by Hollywood
Racks) is a purchaser’s exclusive remedy under this warranty. Damage to a purchaser’s vehicle, cargo, bicycles and or to any other
person is excluded. This warranty is expressly made in lieu of any and all other express warranties, whether oral or written.
Hollywood Racks shall not be liable for any direct, indirect, consequential, incidental, special, punitive or any other damages in
connection with the purchase, use or handling of this product. Some states do not allow the exclusion or limitation of consequential or
incidental damages and the above limitation may not apply to you. This warranty gives you specific legal rights and you have other
rights, which vary from state to state.
Hollywood Racks
Quality bicycle racks since 1973
12812 S. Spring St. Los Angeles, CA 90061
Tel (310) 516-8600 (800) 747-4085 FAX (310)516-8955
www.hollywoodracks.com email: [email protected]
Customer Service Hours: M-F 8:00AM to 3:00 PM PST
Made in Taiwan
010710
Final Step: Install wheel tube stop screws: After you have installed the
bikes on the rack and are comfortable with the positions of the wheel holders,
the stop screws can be installed. Locate items P from hardware bag. Thread
them into the hole located on the bottom of wheel tubes (Fig. 20), and tighten
with a flat edge screwdriver. The screws are removable.
Fig. 20a
Fig. 20b
8