Hollywood Racks HR1000R SportRider 2 Recumbent - Manual (Page 4)

4
Installation and operation of “Precision-Slide” Clamp System
Step 1 : Install the “Precision Slide” clamps on the vertical post:
Position the long frame hook on top of the round vertical post facing the
vehicle. Squeeze the lever and the tab together, so that the lever is all
the way up (engaged). Now wiggle the plastic housing down onto the
tube aligning the index guides with the index slots. You may have to
gently tap it with your other hand. Remember the lever must be
engaged to install it onto the tube. Repeat for the short hook facing
in the opposite direction.
Step 2: Using the clamps:
After the clamp is installed, it can only be raised by engaging the
lever. The clamp can physically be pushed down without engaging the
lever but it is highly recommended that the lever also be engaged
when lowering the clamp.
Installation of small wheel holders