Hollywood Racks HR1450 SportRider SE User Manual
Page 4
Step 4: Installing extension
assembly for 4 bike capacity
Note: Remove front square reflector cap
B1. You will need a Phillips head
screwdriver (screw located on bottom
of tube. (Please put it someplace where
you won’t lose it!)
Slide extension assembly all the way into
base assembly B per Fig. 4a.
Insert the pin through the holes. Be sure
that the pin passes through the welded
loop on the end the bolt attached to the
lever N. (same procedure as in step 1).
Then install clip R through the pin.
Tighten lever N until good and snug. Do
not over torque!
Step 5: Fold Up and Tilt Down features
To fold up the main beam, you must first fold
down the vertical post (B). Refer to
Fig. 5a: Rotate and remove pin A, then rotate
the post (B) and replace the pin in either holes
C.
Next, refer to Fig. 1a: remove clip R from pin
H6, then remove pin H6.
Finally, rotate main beam upward and re-install
pin H6 and clip into hole H2 per Fig. 1a & 5b
3
Fig. 4a
Fig. 4b
Fig. 4c
Fig. 5a
Fig. 5b
Step 4: for installation of HR1475
2 bike add-on kit (sold separately)