Hollywood Racks HR1450 SportRider SE User Manual
Page 3
Step 2: Install Wheel Holders:
Rotate and remove L pins from holes
A. Rotate wheel tubes to a horizontal
position, then replace L pins into holes
B as indicated.
Slide wheel Holders E and F onto
wheel tubes as indicated.
2
Position the long frame hook on top of the round vertical post facing
the vehicle. Squeeze the lever and the tab together, so that the lever
is all the way up (engaged). Now wiggle the plastic housing down
onto the tube aligning the index guides with the index slots. You may
have to gently tap it with your other hand. Remember the lever
must be engaged to install it onto the tube. Repeat for the short
hook facing in the opposite direction.
Using the clamps:
After the clamp is installed, it can only be raised by engaging the
lever. The clamp can physically be pushed down without engaging
the lever but it is highly recommended that the lever also be
engaged when lowering the clamp.
Fig. 2a
Fig. 2b
Fig. 3a
Fig. 3b
Fig. 3c
Fig. 3d
Step 3: Installation and operation of Clamp System
Fig. 2c
After installing wheel holders, install
the “stop” screws (item P) into the
bottom of the wheel tubes as indicated
in Figure 2c. Use Phillips screwdriver.
Item P