Craftsman 917.28934 - Manual (Page 7)

Vt5}3=:c< i/>-i-s;ri-J
.......................
Keys
Slope Sheet
(1) Oil Drain Tube
For Future Use
(2) Keys
SEMBLY/PRE-OPERATION
_
_____ ____
_
____ --------------
-
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 5/16'’ wrench
(2) 7/16" wrenches
(2) 1/2" wrenches
(1)9/16" wrench
Utility knife
Tire pressure gauge
Pliers
(1) 3/4" wrench
(1) 3/4" socket with drive ratchet
When right or left hand is mentioned in this
manual, itmeanswhen youare inthe operating
position (seated behind the steering wheel)
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1 Cut along dashed lines on all four pan­
els of carton . Remove end panels and
lay side panels flat.
2. Remove protective materials from trac­
tor hood and grille,,
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
CHECK BATTERY
1, Lift seat pan to raised position and
open battery box door.
NOTE: If this battery is put into service after
month and year indicated on label (label
located between terminals) charge battery
for minimum of one hour at 6-10 amps,
(See "BATTERY" in Maintenance section
of this manual for charging instructions)
ADJUST SEAT
1, Sit in seat.
Lift up adjustment lever (A) and slide
seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
Release lever to lock seat in position.