8 - starting and stopping a program – Hudson Robotics Micro10x User Manual
Page 20
20
Figure 2.7.7
Adjust Row/Column Spacing - This setting is set by the manufacturer and should
not be adjusted.
# Of Tips in Manifold - This setting is set by the manufacturer and should not be
adjusted.
2.8 - Starting and Stopping a Program
Press the Next or Prev key on the TouchScreen to select the program number you
would like to run. When the desired program is selected press the RUN button on
the TouchScreen (Figure 2.8.1). To stop a program, press the CANCEL button on
the TouchScreen. The dispenser will pause, you may then choose to abort or
continue the dispense program. To abort the program, press YES, to complete the
program, press NO.