Hudson Robotics Micro10x - Manual (Page 12)

12
Orientation– Select between the Portrait or Landscape plate orientation. This is
determined by which manifold you are working with.12 channel will run in
landscape while the 8 channel runs in portrait configuration.
Tip Touch – Activate or deactivate tip touching.
Tip Touch – Adjust where in the plate well you would like the tips to touch after
the dispensing. Depending on the plate type, you will center your tips in row A of
either a 96 or 384 well plate. Once the tip is centered you will adjust the Y-axis
either to the front or rear of the well until the tip is touching the plates well. A
good location for the height of the tip is ~1mm below the top of the Plate (Figure
2.3.2).
Figure 2.3.2
Fill Pattern – Select the rows you would like to fill, the default is all wells.
2.4 - Prime Submenu
The MC10X can store up to 10 prime programs. Fields are adjusted in the same
manner as the Dispense programs (Figure 2.4 1).