Autocue WINCUE User Manual
Page 85
WINCUE USER GUIDE
APPENDIX B
85
AUTOCUE LTD. 2002
When a dipswitch is in the top position it is on. When it is in the bottom
position it is off. The dipswitch positions for SCSI/parallel port selection is
shown in the table below:
Dip Switch
Port
4
SCSI
Off
Parallel
On
B5 Video (PAL or NTSC) - J11
The I.M.T. card can produce either a PAL or NTSC composite video signal.
The signal available from the composite video port will have been set at the
factory, prior to dispatch. The signal type can be changed by setting a
jumper on J11 (Card Issue 1) or with switch 3 (Card Issue 2).
Issue 1
Issue 2
To enable NTSC place a jumper on leftmost
pins of J11, or turn Switch 1 on.
To enable PAL remove the jumper on
leftmost pins of J11, or turn Switch 1 off.