Autocue WINCUE User Manual
Page 83
WINCUE USER GUIDE
APPENDIX B
83
AUTOCUE LTD. 2002
B3 Termination - J6
By Default the I.M.T. card is terminated, and expects to be connected to the
end of the SCSI cable. Termination can be enabled/disabled by changing a
jumper setting on J6.
To enable termination of the I.M.T. card place a jumper
on leftmost pins of J6
To disable termination of the I.M.T. card remove the
jumper on leftmost pins of J6
B3 Power to Bus for SCSI Termination - J6
J6 is used to determine whether the I.M.T. card is terminated and to
determine the source of termination power.
If you have enabled termination on the SCSI card you will need to set the
source of termination power.
To enable external termination power for the SCSI bus
connect pins 5 and 7 of J6
To enable internal termination power to the SCSI bus connect
pins 7 and 8 of J6
See below to learn about
power to bus SCSI
Termination settings