Zero Gravity Honda VFR 1200F (2010 and up) Windscreen - Manual (Page 3)

Honda VFR 1200F 2010 - 2013 DIY Windscreen Install
3
455 install
SPORTBIKE SADDLES & WINDSCREENS
WWW.ZEROGRAVITY-RACING.COM
FIG8
Fig 9. Replace finish plate back to it’s respected lo-
cation. Starting from the bottom clip and work your
way up.
FIG 9
Fig 8. Remove both left and right factory rubber grom-
met and install them to Zero Gravity screen (as shown
above.) Then assemble one small plastic washer
(provided) to each of the four factory allen screws.
Fig 11. Carefully pull back on the top side fairing
while slipping the ZG screen tabs into the appropriate
slots. Use the mirror mounting point for a reference to
position the screen. Install provided allen screws and
plastic washers. Bolt on side mirrors to finish.
FIG11
Position tabs into the
slots on both sides
Please see www.zerogravity-racing.com for
further information concerning this product.
Note: Revert back to Fig 5 ~ Fig 10 if alignment is
not achieved.
FIG 10
Fig 10. Before installing windscreen, place one
washer to each of the mirror peg (as shown above.)
The windscreen WILL BE ON TOP of these washers.
Four
Washers
Included
Position washer to
each mirror peg
Installed With
Windscreen
Installed
One plastic washer
per allen screw.
Factory Grommet