Zero Gravity Honda VFR 1200F (2010 and up) Windscreen User Manual

Fig2 fig2a, Fig3, Fig1

Honda VFR 1200F 2010 - 2013 DIY Windscreen Install

455 install

SPORTBIKE SADDLES & WINDSCREENS

Fig 2A.

HERE IS THE TRICKY PART! Locate the

fairing retention clip and windscreen T-Hooks before
applying any movement pressure. There will be
two T-Hooks, one on each side.

(See FIG3).

Fig 2.

After removing the mirrors, flex the corner fair-

ing to expose the next step in unhooking the stock wind-
screen as shown in

Fig 3.

Helpful hints: Use metric tools, clean hands, put the bike on a stand. Do not pry on the screen excessively, as it can break

without warning.

Installation Instructions for Honda VFR 1200F 2010 and up.

Thank you for purchasing Zero Gravity windscreen, which has been designed and manufactured to give years of safe &
fun riding. These instructions give you an in-depth look at the

installation process.

To receive further assistance or parts please

e-mail [email protected].

PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN

FIG2

FIG2A

Fig 3.

Separate T-Hooks from the retention clip by

applying a light pressure from the corner fairing and
work the light pressure down as shown. (Both Sides)

Be careful not too exert to much force!

FIG3

Fig 1.

Remove both mirrors. Locate both fasteners

located on the inside fairing. Also, remove inner plas-
tic that’s covering both left & right two allen screws.

Fairing

T-Hooks

Clip and T-Hook must

be separated before

removing screen .

Flex the

corner of

the fairing.

(Both sides)

Fairing

Retention

Clip

FIG1

Remove two

allen screws

(bothsides)