Zero Gravity Honda CBR 1000RR (12-13) Windscreen - Manual

Honda CBR1000RR 2012 - 2013 DIY Windscreen Install
1
426 install
SPORTBIKE SADDLES & WINDSCREENS
Fig 3. Locate the windscreen fairing slot, windscreen
retention pegs and bottom wellnut fairing frame before
you install your new ZG windscreen.
Caution: Those retention pegs are fragile and will break off if
forced.
FIG1
Helpful hints: Use metric tools, clean hands, put the bike on a stand. Do not pry on the screen excessively, as it can break
without warning.
Installation Instructions for Honda CBR 1000RR 2012 - 2013
Thank you for purchasing Zero Gravity windscreen, which has been designed and manufactured to give years of safe &
fun riding. These instructions give you an in-depth look at the
installation process. To receive further assistance or parts please
e-mail [email protected].
PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN
FIG2
FIG3 FIG4
Fig 1. Loosen both mirrors. Locate both fasteners lo-
cated on the inside fairing. Be careful not to drop the
mirrors or lose the nuts. Remove bottom wellnuts ( for lo-
cation see Fig 2 ) first. To remove bottom wellnuts sim-
ply pull wellnuts out. It’s a bit of a pull since there are
two layers (windscreen & fairing frame). Once removed
pull windscreen towards the back, while guiding and
pushing the front windscreen.
Remove Grommet and Wellnuts and
transfer them to the ZG screen.
Windscreen
Fairing Slot
Windscreen
Retention
Pegs
Grommet Locations
Bottom Wellnut
Top Wellnut
Bottom
Left
Wellnut
in place
Bottom Well-
nut Fairing
Frame
Bottom
Right
Wellnut
NOT
in place
Both grommet holes
are in line with pegs
Fig 4. While installing the windscreen, postion ONE
side of the bottom wellnut first, (Shown Bottom left side
in first) and also guide the grommet holes into the pegs
(Both Sides for the grommet)
Be careful not too exert to much force!
Removing Factory Screen
Wellnut/Grommet Transfer / Front Slot Location
Wellnut/Peg Overview Screen Install Left Side
Tip of the screen
Front Slot Location
Fig 2. Make sure to transfer all grommets and well-
nuts as shown above in the same way they were in-
stalled on your OEM screen.
Note the location: Tip of the screen, this will be impor-
tant in the install process.
Caution: Tip of the screen are
fragile and will break off if applied with heavy pressure.
WWW.ZEROGRAVITY-RACING.COM