Wood’s Powr-Grip P11104AC - Manual (Page 15)

Rev 10.0/6-12 13 P1-AC: #35110
A
FTER
U
SING THE
L
IFTER
Leave the valve handle in the “RELEASE” position and place the power switch in the “OFF”
position.
CAUTION: Do not set the lifter against any surfaces which could soil or damage the
vacuum pads.
The control handle at the end of the pad channel can be used to support an unloaded lifter when
not suspended from a crane: Make sure the pad channel is oriented vertically with the control
handle at the bottom. Use the hoisting equipment to gently lower the lifter until the control
handle supports the entire weight of the lifter. Make sure the lifter leans securely against an
appropriate support; then detach the hoisting equipment hook from the lift bail.
If the lifter is transported to another location, use the original shipping container and secure the
lifter so as to protect the vacuum pads and all other components from damage while in transit.
Storing the Lifter
Use the covers supplied to keep the vacuum pads clean.
!!-CE-!! In accordance with CE Standard EN 13155, the lifter is designed to rest on relatively
horizontal surfaces without tipping over. To store the lifter in this way, set the lifter with the
pads facing downward on a clean, smooth, flat surface. Then lower the lift bar to a horizontal
orientation and place a support under the lift bail.