Barco R9806700 - Manual (Page 33)

8. Operating the Remote Control
8. OPERATING THE REMOTE CONTROL
Overview
• Battery Insertion in the Remote Control
• Operating the Remote Control
• Address setting for the Remote Control
8.1 Battery Insertion in the Remote Control
– Insert batteries so that the plus (+) and minus (-) sides are aligned according to the markings in the battery
case.
– Do not mix new batteries with used ones.
– The voltage of batteries may differ even if they are the same shape. Please do not mix different kinds of
batteries.
– When not using the remote control unit for a long period of time (1 month of more), remove the batteries
from the remote control unit to prevent leaking of battery fluid. If battery liquid has leaked, thoroughly wipe
the inside of the case until all liquid is removed, an then insert new batteries.
- Do not charge, short, disassemble or throw the provided batteries in a fire.
When disposing of used batteries, please comply with governmental regulations or environmental public in-
struction’s rules that apply in your country.
Where to find the batteries
The batteries are not placed in the remote control to avoid remote control operation in its package, resulting in a shorter battery life
time.
The batteries are packed separately and added to the package of the remote control.
How to install the batteries
1. Push the cover tab (A) with the fingernail a little backwards and pull upwards the cover top (B). (image 8-1)
2. Slide the cover forwards to remove. (image 8-2)
3. Push the battery body towards the spring and lift it up to remove. (image 8-3)
4. Insert two AA size batteries, making sure the polarities match the + and – marks inside the battery compartment (image 8-3).
5. Insert the lower tab of the battery cover in the gap at the bottom of the remote control, and press the cover until it clicks in place
(image 8-3).
Image 8-1
Battery cover unlock
Image 8-2
Battery cover removal
R5976519 ACSAR 12122002 29