Brother HL-1070 - Manual (Page 64)

USER’S GUIDE
6–2
For errors shown below, the printer indicates an operator call by blinking
the
Alarm lamp. If you use the printer with the supplied Windows driver,
the status monitor will appear to indicate the error on your computer
screen. The printer also prints some error messages on paper.
Error Action
Cover Open Close the top cover of the printer.
Print Overrun
Press the panel switch to print the data remaining in the
printer.
If you are using the supplied Windows driver, try again after
changing the following settings. The best combination of the
settings below will vary depending on your document.
Graphics Mode
TrueType Mode
Use Printer True Type Fonts
Page Protection
If this does not clear the error, reduce the complexity of your
document or reduce the print resolution.
Expand the printer memory by installing a SIMM and set
page protection to ON by using the supplied Windows driver
or RPC program.
Memory Full
Press the panel
switch to print the data remaining in the
printer.
If you are using the supplied Windows driver, try again after
changing the following settings. The best combination of the
settings below will vary depending on your document.
Graphics Mode
TrueType Mode
Use Printer True Type Fonts
Page Protection
Expand the printer memory by adding a commercially
available SIMM.
Reduce the print resolution or reduce the complexity of your
document.
Parallel Interface Line
Error
Press the panel
switch to resume printing.
Check that the connection between your computer and printer
is secure and correct, and check the interface cable.
Serial Interface Framing
Error
Press the panel switch to resume printing.
Check the communication parameters such as baud rate and
stop bit on both your computer and printer.
Serial Interface Parity
Error
Press the panel switch to resume printing.
Check the communication parameters such as bit length and
parity on both your computer and printer.
Serial Interface Overrun
Error
Press the panel
switch to resume printing.
The interface hardware may be damaged. Consult your dealer.