Brother HL-1070 - Manual (Page 34)

CHAPTER 3 CONTROL PANEL
3–3
Alarm Lamp
The Alarm lamp blinks to indicate a printer error status such as “Cover
Open” and “Memory Full.” If any other error occurs, the printer indicates
the error by blinking the
Alarm lamp with another lamp or by printing an
error report.
✒ Note
The
Ready , Data and Drum lamps are used to indicate printer errors
with the Alarm lamp. See “ALARM INDICATIONS AT A GLANCE” in
Chapter 6 and take corrective action for the error.
Switch
This switch will be used as the following purpose depending on the
situation.
Cancel Printing
If you press the switch during printing, the printer immediately stops
printing and ejects the paper.
Wake-up
If the printer is in sleep mode, pressing the switch wakes it up into the
ready state.
Form Feed
If the Data lamp is on, press the switch . The printer prints any data
remaining in the printer memory: this operation is called “Form Feed.”
Error Recover
If an error occurs, the printer will recover from some errors
automatically. If the error does not clear automatically, press the
switch to
clear the error and continue printer operation.
Select Feeder
If the Ready lamp is on, press the switch . You can select Feeder 1 or
Feeder 2.