Dascom 2600 User Guide - Manual (Page 92)

Tally Dascom 2610
79
7.2 Control Codes Summary
The following table shows sequences marked by a √ if they are available in the various
emulations. The MTPL sequences can be used within all emulation modes. The corresponding
sequences are marked by a *.
I f you want to learn more about control codes, we recommendto download
the Programmer’s Application Manual from our internet support pages.
MTPL
IBM
XL24
IBM
AGM
Epson
LQ-2550
Epson
LQ-2170
Code Function
√ √ √ √ Signal tone
√ √ √ √ √ Control character BS (Backspace)
√ √ Deleting a data line
√ √ √ √ √ Control character CR (Carriage return)
√ Start character for MTPL sequences, corr. ESC [
√ √ Selecting the printer
√ √ Condensed printing OFF (set by or )
√ √ Deselecting the printer
√ √ Double-wide printing OFF (set by or )
√ √ * √ √ Delete line. Epson: Delete last character
√ √ √ √ √ Start character for programming sequence
√ √ √ √ ! Print mode selection
√ √ √ # Bit 8 = unchanged
√ √ $ Perform absolute horizontal step
√ √ %<0><0> Select ROM character generator
√ √ %<1><0> Select download generator
√ * * * * %1 Graphics print with 180 dpi/HQ
√ * * * * %2 Graphics print with 360 dpi/HQ
√ * * * * %3 Graphics print with 60 dpi
√ * * * * %4 Graphics print with 120 dpi
√ * * * * %5 Graphics print with 80 dpi
√ * * * * %7 Graphics print with 240 dpi
√ * * * * %8 Graphics print with 72 dpi
√ * * * * %9 Graphics print with 90 dpi
√ √ &.. Define download character
√ * * * * (& Character set ISO 8859-2
√ * * * * (* Character set ISO 8859-5
√ * * * * (+ Character set ISO 8859-1 SAP