InnoMax Hardside Fluid User Manual

Page 9

STEP 7: FILLING THE WATER MATTRESS

From your bathroom faucet, remove the aerator by unscrewing

it. (If your bathroom faucet does not have an aerator, you will

have to use your kitchen faucet or an outside faucet.)

Attach the faucet connector you purchased with your

waterbed care kit, into your faucet. Next attach a garden hose

to the faucet connector. Make a tight fit to avoid spray leakage

(a towel placed over the faucet while filling will keep any

leakage from spraying.) To help eliminate unclean water in your

bed, flush running water though the garden hose for about 10

minutes before filling your bed.

Pour in your waterbed conditioner. Attach the waterbed hose

connector onto your garden hose. Insert it into your "popped-

up" valve and attach the hose connector and valve securely

together to avoid leakage. Wrap a towel around this connector

to soak up any unavoidable leakage.

STEP 6: INSTALL SAFETY LINER AND MATTRESS

Simply spread out the Stand-Up liner inside your frame. It will

stand-up inside the frame by itself.

Smooth out the wrinkles,

especially over the heating pad!

Lay out your watermattress inside your safety liner with the

valve at the foot. Carefully avoid shifting any of the baffle

inserts, if you bought a motion reduced mattress. Remove the

wrinkles on the bottom and make sure the mattress is evenly

centered.

Align the corners of the mattress with the corners of the

frame. If your safety liner, heating pad, or thermostat sensor

shifted during this process, reposition it now.