InnoMax Hardside Fluid User Manual

Page 7

STEP 3: LAY THE DECK BOARDS ON THE PEDESTAL

King size - position the three 24 inch deck board pieces so that

the pedestal is equally recessed on all sides. The cut corners on the

deck boards should be positioned at the four corners.

Queen size - position the two 24 inch deck boards, with the

one 12 inch deck board in the middle, so that the pedestal is

equally recessed on all sides. The cut corners should be posi-

tioned at the four corners.

Super Single size - position the two 24 inch deck boards so that

the pedestal is equally recessed on all sides. The cut corners on the

deck boards should be positioned at the four corners.

STEP 4: MOUNT THE FRAME TO THE DECK

Lower the frame onto the deck. Make sure the grooves on the

bottom of the footboard and backboard overlap the deckboards.

Re-check that the pedestal is centered and in position.

This photo shows how the grooves overlap the deck.

Attach the “L” bracket into the middle of each frame board

and deck to secure the deck to the frame. To protect liner and

mattress from metal burrs, cover all inside metal brackets with

masking or duct tape.

If your waterbed features a bookcase headboard, mount it to

the frame now. Secure the headboard to the frame with the flat

brackets screwed in from underneath the headboard behind the

frame. Slide the frame carefully away from the wall a few

inches, if needed, to allow more room to mount. Once mounted

slide the frame back into final position.