InnoMax Hardside Fluid User Manual

Page 11

Electric Pump Usage/Draining Instructions:

Unplug Heater Before Draining!

If interested in using an electric pump, please ask your dealer for more information.
1.

Remove all of the air from your mattress.

Attach the “perfect union” connector on the

end of the clear hose on the pump to the valve

in your mattress. Make sure all washers are

used and the connections are tight to maintain

proper suction.

Connect your exit hose to the discharge port

on the pump. Ensure the exit hose is in the

desired location. The force of the water can

actually cause the hose to flop about and come

out of a normal bathtub. Do not leave the hose

unattended while indoors. Place the pump on

a towel or cardboard piece to prevent possible

damage to the floor or other surface.

Plug the pump into a grounded electrical

outlet. Note: There is no on/off switch and

the pump will begin to operate immediately.

Allow the pump to run until the water

slows to a trickle. The pump will remove

nearly all of the water & the mattress will

become “vacuum-sealed” to ensure all

internal support features remain in their

proper location. Do not lift the head of the

mattress until the mattress is vacuum

packed, as this could damage the mattress.

Immediately unplug the pump. Do not run

the pump without water for an extended period

of time, as this can severely damage the pump.

Disconnect the perfect union connector

from the mattress and immediately insert

the cap and seal to ensure the mattress

remains vacuum packed.

If the mattress is still too heavy to move, you can utilize a shop (wet/dry) vacuum to get the remainder of the water out

Contact Your Dealer For Rental Info.

or To Purchase The Drain Hero™ -

10 Piece Maintenance Kit.

Unplug The Waterbed Heater Before Draining The Mattress

ELECTRIC PUMP DRAINING INSTRUCTIONS

Once water is flowing into the bed for a few seconds, turn the

"bell valve" to the "down" position, leaving the water flowing full

blast. The water from your faucet flowing through your drain

pump will suck the water out of your bed. This will take one or

two hours depending on water pressure. Do not allow air to get

in the hose.

If you have a motion reduced mattress you must show

special care while draining and moving your bed to prevent the

interior fiber layers from shifting.

FOLD YOUR MATTRESS CAREFULLY. DO NOT LET THE

FIBER LAYERS SHIFT OUT OF PLACE.

If any shifting does

occur, you should reposition them before refilling your mattress.