beautypg.com

4 about the power connect™ feature, About the power connect™ feature, N 3.2 – Kramer Electronics TP-107AVR User Manual

Page 9

background image

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Overview

6

3.2 Controlling via the RC-108 and RC-116 Presentation Controllers

The RC-108 and RC-116 are presentation controllers designed specifically to

control a BoardView™ system

1

. Each presentation controller has the

appropriate number of input selector buttons

2

3.3 Shielded Twisted Pair (STP)/Unshielded Twisted Pair (UTP)

, an RS-485 and 12V DC port

and an RS-232 9-pin D-sub port for firmware upgrade.

We recommend that you use Shielded Twisted Pair (STP) cable, and stress

that the compliance to electromagnetic interference was tested using STP

cable. There are different levels of STP cable available, and we advise you

to use the best quality STP cable that you can afford. Our non-skew-free

cable, Kramer BC-STP is intended for analog signals where skewing is not

an issue.
In cases where there is skewing, our Unshielded Twisted Pair (UTP) skew-

free cable, Kramer BC-XTP, may be advantageous, and UTP cable might

also be preferable for long range applications. In any event when using UTP

cable, it is advisable to ensure that the cable is installed far away from

electric cables, motors and so on, which are prone to create electrical

interference.

3.4 About the Power Connect™ Feature

The Power Connect feature applies as long as the cable can carry power.

This feature is available when using STP cable and the distance does not

exceed 50m on standard CAT 5 cable. For longer distances, heavy gauge

cable should be used

3

For a CAT 5 cable exceeding a distance of 50m, separate power supplies

should be connected to the transmitter and to the receiver simultaneously.

.

For units which are connected via RJ-45 connectors,

make sure that the shield of the STP cable is connected to the metal casing

of the connectors on both ends of the cable. For units which are connected

via terminal block connectors, the shield of the STP cable must be

connected to a ground terminal on the units at both ends (use the ground

terminal of the power supply connection if necessary).

1 Up to eight and up to 16 units, respectively
2 Eight and 16 buttons, respectively
3 CAT 5 cable is still suitable for the video/audio transmission, but not for feeding the power at these distances

This manual is related to the following products: