Kramer Electronics TP-107AVR - Manual (Page 16)

Configuring a TP-107AVR System
13
13
5 Configuring a TP-107AVR System
This section describes how to:
• Connect the TP-107AVR (see Section 5.1
• Configure a TP-107AVR/TP-122 BoardView™ kit (see
)
Section 5.2
• Connect the RC-108/RC-116 Presentation Controller to the
BoardView™ kit (see
)
Section 5.3
• Wire the CAT 5 LINE IN/LINE OUT RJ-45 connectors (see
)
Section 5.4
• Connect via the K-NET terminal block connector (see
)
Section 5.5
• Set the address number (see
)
Section 5.6
5.1 Connecting the TP-107AVR/TP-122 Transmitter/Receiver
System
)
To connect the TP-107AVR XGA/Audio Line Transmitter with the TP-122
XGA/Audio Line Receiver, as the example in Figure 9 illustrates, do the
following:
1. On the TP-107AVR, connect an XGA source (for example, a
computer graphics source) to the XGA IN 15-pin HD computer
graphics connector and an audio source to the audio IN 3.5mm mini
jack, for example, using a Kramer C-GMA/GMA cable (VGA 15-pin
HD (M) + audio jack to VGA 15-pin HD (M) + audio jack) 1
2. On the TP-122, connect the XGA OUT 15-pin HD (F) connector to
the XGA acceptor (for example, a display), and connect the AUDIO
OUT S/PDIF RCA connector to the digital audio acceptor (for
example, an AV receiver), and the ANALOG 3.5mm mini jack to the
analog audio acceptor (for example, a stereo audio recorder).
.
3. Connect the LINE OUTPUT RJ-45 connector on the TP-107AVR to
the LINE IN RJ-45 connector on the TP-122, via STP cabling 2 (with a
range of up to 300ft (100m)), see Section 5.4
4. Connect a 12V DC power supply to each power socket on the
TP-107AVR and the TP-122, and connect the power supplies to the
mains electricity.
The signal from the XGA source is transmitted via CAT 5 cable,
decoded and converted at the XGA OUT 15-pin HD (F) connector to
the XGA acceptor.
.
1 Not supplied. The full list of Kramer cables is on our Web site at http://www.kramerelectronics.com . Alternatively, you can
connect an XGA source to the XGA IN 15-pin HD computer graphics connector, and a separate audio source to the AUDIO
IN 3.5mm mini jack
2 The Kramer BC-STP cable is recommended