AZEK Rail - Manual (Page 14)

Page 14
Installing AZEK Rail Stairs with CableRail by Feeney ®
Use a scrap piece of baluster trimmed at the
stair angle as a guide.
Anchor posts should not exceed 60 feet apart
during any continuous run of cable.
Installing Cable Installation Section
PRE-DRILL ANCHOR POST SLEEVE
1
11
Drill a through hole only in the
post sleeve with a 1/4” drill bit at
the same angle as the stair run
Scrap
Baluster for
drill angle
1/4”
1/8”
1/4”
1/8”
INSTALL TOP RAIL AND POST CAPS
• Position Top Rail over Support Rail and attach with screws.
• Secure Post Caps with exterior grade caulk.
Pre-drill 3/16”
#8 x 2 5/8”
Coated Screws
Installing CableRail by Feeney ® Stairs for AZEK Rail