Nor-Lake envIro-lIne - Manual (Page 29)

© 2013 Nor-Lake, Inc 07/13 Rev. F 132617 27
SEALANT
Step 1
After floor sections are in place and fully
locked together, apply approximately
1/8” bead of sealant to the interior metal,
3/8” in from the ramp cut out. Also apply
approximately 1/8” bead of sealant to the
center of the exterior metal lip.
Step 2
Place ramp into position by lining up the pre-
drilled holes in the ramp with the pre-drilled
in the interior floor then secure the ramp into
the floor with the #8 x 1/2” screws provided.
Step 3
Install non-skid floor fabric 6” x 24” Non-skid
applied to cover ramp base and back seam of
ramp to floor 3” x 24” non skid applied to cover
side seam of ramp base to floor.
Apply sealant where the door section meets the
interior and exterior of the floor panel and ramp.
Also, apply sealant under the door threshold.
Interior Ramp Installation Instructions
i
nTeRioR
R
amP
i
nsTallaTion
i
nsTRucTions