beautypg.com

General safety information, Server operation and maintenance precautions – 8e6 Technologies TAR MSA-004-004 User Manual

Page 20

background image

6

8

e

6 T

hreaT

a

nalysis

r

eporTer

Q

uick

s

TarT

G

uide

General Safety Information

Server Operation and Maintenance Precautions

Warning:

Observe the following safety precautions during server operation and maintenance:

WARNING: If the server is used in a manner not specified by the manufacturer,

the protection provided by the server may be impaired.

WARNING: 8e6 Technologies is not responsible for regulatory compliance

of any server that has been modified. Altering the server’s enclosure in any way

other than the installation operations specified in this document may invalidate the

server’s safety certifications.

CAUTION: Never pile books, papers, or other objects on the chassis, drop it,

or subject it to pressure in any other way. The internal circuits can be damaged,

and the battery may be crushed or punctured. Besides irreparable damage to the

unit, the result could be dangerous heat and even fire.

CAUTION: There are no user-serviceable components inside the chassis.

The chassis should only be opened by qualified service personnel. Never disas-

semble, tamper with, or attempt to repair the server. Doing so may cause smoke,

fire, electrical shock, serious physical injury, or death.

Do not insert objects through openings in the chassis. Doing so could result in a

short circuit that might cause a fire or an electrical shock.

Do not operate the server in an explosive atmosphere, in the presence of flammable

gases.

To ensure proper cooling, always operate the server with its covers in place. Do not

block any openings on the chassis. Do not place the server near a heater.

Always exit the software application properly before turning off the server to ensure

data integrity.

Do not expose the server to rain or use near water. If liquids of any kind should leak

into the chassis, power down the server, unplug it, and contact 8e6 Technologies

technical support.

Disconnect power from the server before cleaning the unit. Do not use liquid or aero-

sol cleaners.