Choosing a scsi id number – AGFA Scanner User Manual
Page 24
Chapter 2 — Installing the scanner
24
Choosing a SCSI ID number
If you installed the AVA 1502-P card:
Before you connect your SnapScan to your PC, you have to find out which SCSI ID numbers are
already assigned and which numbers are free.
1.
Open the Adaptec SCSI interrogator.
or
Check at the rear of your devices if SCSI ID number 2 is free.
Your SnapScan is preset to ID 2.
2.
If SCSI ID number 2 is not free, you need to set the scanner to a free SCSI ID number:
1.
Make sure your scanner is switched off and is disconnected from your computer.
2.
Decide on an unassigned SCSI ID number.
3.
Push the button above or underneath the SCSI ID number at the rear of the scanner until
you see the number you want.
Push the button above the SCSI ID number to decrease the number, push the button
underneath the SCSI ID number to increase the number.