AGFA Scanner User Manual
Page 17
Chapter 2 — Installing the scanner
17
Your Macintosh always occupies ID 7, its internal hard disk usually occupies ID 0 or ID 1 and CD
ROM usually occupies ID 3. If your Macintosh is equipped with 2 SCSI-busses, the button Next
Bus allows you to switch busses.
3.
Check if SCSI ID number 2 is free.
Your SnapScan is preset to ID 2.
■
If SCSI ID number 2 is free, click OK to close the SCSI ID Checker.
■
If SCSI ID number 2 is already assigned, you need to set the scanner to a free SCSI ID number.
1.
Make sure your scanner is switched off and is disconnected from your computer.
2.
Decide on an unassigned SCSI ID number.
3.
Push the button above or underneath the SCSI ID number at the rear of the scanner until
you see the number you want.
Push the button above the SCSI ID number to decrease the number, push the button
underneath the SCSI ID number to increase the number.
4.
Click OK to close the SCSI ID Checker.