Phottix Odin for Nikon - Manual (Page 7)

Turning the TCU and receiver on/off
Groups and Channels
The TCU
Connecting to the camera hot shoe
1. To turn on the Phottix Odin TCU: Press and
hold the Power Button until an image appears
on the LCD screen.
To turn off: Press and hold the Power Button
until the LCD screen goes blank.
2. To turn on the Phottix Odin receiver: Move
the power switch to the “ON” position.
To turn off the receiver by moving the power
switch to the “OFF” position.
1. The Phottix Odin System has 3 groups: A, B,
and C, and 4 transmission channels: 1, 2, 3, 4.
2. Receivers can be assigned both group and
channel designations.
3. The TCU will allow EV, Power Level and Zoom
setting adjustments to be set for each group of
receivers set to same channel (if the group is
not disabled on the TCU)
1. Turn off the camera.
2. Slide the Odin TCU into the camera’s hot
shoe mount.
7
En INSTRUCTION MANUAL
6. When the battery power on receivers is very
low, the LED will flash red light every 2 seconds.
Please change the batteries.