Videoswitch Vi-K3 - Manual (Page 32)

Vi-K2/Vi-K3 Universal
Keyboard
Vi-K2 Universal Keyboard User Manual
30
Repeat these steps for each position in the tour:
• The display will show the letters “PoS”, flashing (asking for a preset position).
• Enter the next preset position number 1, 2, 3…16.
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “dLL”, flashing (asking for a dwell time).
• Optionally enter a new dwell time (0, 1, 2…99 where each increment represents about 2
seconds).
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “Spd”, flashing (asking for a speed).
• Optionally enter a speed value to determine the speed of movement between one position and
the next (
0, 1, 2…99).
• Holding
the
ALT key on, press the PROG key, and repeat for all positions.
To finish programming a tour:
• The tour can be finished when the letters “PoS” are displayed, as follows:
• Holding
the
ALT key on, press the PROG key (i.e. without entering another position) to finish
the tour programming.
• The word “Fin” will be displayed, indicating that the tour programming has finished.
• Finally, Holding the ALT key on, press the PROG key to return the display to its normal mode.
8.9 Other Commands
8.9.1 Lens Slow
Press and hold the
ALT key and press the F9 key to toggle the lens speed between normal and slow.
8.9.2 Receiver Reset
Press and hold the
ALT key and press the F4 key to reset the receiver. This should be done when the
system is installed, with pan/tilt head connected, to initialise the presets.